Preparation of a novel bentonite intercalation composite by changing the chemical state of aluminum

A new environment-friendly bentonite intercalation composite was successfully obtained from alumina sol intercalation. This process used industrial grade pseudo boehmite as the aluminum source and provided with the advantage of zero emission of acidic wastewater. The bentonite intercalation composite was investigated by XRF, ICP, XRD, FT-IR, BET, and pyridine-FTIR. Results indicated that the basal spacing was enlarged from 14.72 to 15.60 Å; the specific surface area increased by 128%; and the total acid content increased from 65.32 to 245.76 μmol/g. The catalytic activity of this composite was tested by alkylation of aromatics with olefins. The results show that the weak Lewis acid generated by extra-framework aluminum and specific surface area play a decisive role, while weak Brønsted acid site is not the active site for this alkylation reaction.     

Noninvasive Temperature Measurement in Dental Materials Using Nd3+, Yb3+ Doped Nanoparticles Emitting in the Near Infrared Region

In this work, the application of near infrared (NIR)-emitting NaYbF₄:1%Tm³⁺@NaLuF₄:30%Nd³⁺ core–shell nanoparticles is reported for noninvasive probing and monitoring the temperature during photopolymerization of dental materials. When excited at 808 nm, the synthesized nanoparticles emit NIR photoluminescence (PL) with two distinctive peaks at 865 and 980 nm which correspond to radiative transitions from the doped Nd³⁺ and Yb³⁺ ions, respectively. Luminescence intensity ratio between these two bands is found to vary with temperature due to temperature-dependent electronic excitation energy transfer between Nd³⁺ and Yb³⁺ ions at the core/shell interface. This finding allows luminescence ratiometric evaluation of the in situ temperature during photopolymerization of resin cement (doped with nanoparticles) in a veneer placement procedure. In addition, the NIR emission also enables PL imaging of the distribution of the adhesive under the veneer. The results highlight that rare-earth ions–doped nanoparticles with both excitation and emission in the NIR spectral range are advantageous for both PL-based nanothermometry and imaging due to the reduced attenuation of NIR light by dental ceramics.     

Lottery and Auction on Quantum Blockchain

This paper proposes a protocol for lottery and a protocol for auction on quantum Blockchain. Our protocol of lottery satisfies randomness, unpredictability, unforgeability, verifiability, decentralization and unconditional security. Our protocol of auction satisfies bid privacy, posterior privacy, bids’ binding, decentralization and unconditional security. Except quantum Blockchain, the main technique involved in both protocols is quantum bit commitment.     

An improved LC–MS/MS method for determination of docetaxel and its application to population pharmacokinetic study in Chinese cancer patients

Because of its unpredictable side effects and efficacy, the anticancer drug docetaxel (DTX) requires improved characterisation of its pharmacokinetic profiles through population pharmacokinetic studies. A sensitive and rugged LC–MS/MS method for the detection of DTX in human plasma was developed and optimised using paclitaxel as an internal standard (IS). The plasma samples underwent rapid extraction using hybrid solid-phase extraction-protein precipitation. The analyte and IS were separated with an isocratic system on a Zorbax Eclipse Plus C₁₈ column using water containing 0.05% acetic acid along with 20 μM of sodium acetate and methanol (30/70, v/v) as the mobile phase. Quantification was performed using a triple quadrupole mass spectrometer through multiple reaction monitoring in positive mode, using the m/z 830.3 → 548.8 and m/z 876.3 → 307.7 transitions for DTX and paclitaxel, respectively. The range of the calibration curve was 1–500 ng/mL for DTX, and the linear correlation coefficient was >0.99. The accuracies ranged from −4.6 to 4.2%, and the precision was no higher than 7.0% for the analytes. No significant matrix effect was observed. Both DTX and the IS showed considerable recovery. This method was finally applied to the establishment of a population pharmacokinetic model to optimise the clinical use of DTX.     

A detailed investigation into the one-pot cascade reaction of ethyl 3,9-dimethyl-7-phenyl-6H-dibenzo-[b,d]pyran-6-one-8-carboxylate with phenylhydrazine

Research on Chemical Intermediates - When synthesizing cyclohexane-annulated pyrazolones from a cyclohexonedicarboxylate derivative with phenylhydrazine under the catalysis of sulfuric acid in the...     

平板几何迁移算子的特征值问题

研究L^p(1相似文献   

Fast Liquid Phase Epitaxial Growth for Perovskite Single Crystals

Semiconductors grown by the solution-processed method have shown low-cost,facile fabrication process and comparable performance.However,there are many reasons why it is difficult to achieve high quality films.For example,lattice constant mismatch is one of the problems when photovoltaic devices made of organ metallic perovskites.In this work,MAPbBr^{MA=CH3NH3^+}perovskites single crystals grown on the surface of MAPbBr2.5 CI0.5 perovskites single crystals via liquid epitaxial growth method is demonstrated.It is found that when the lattice constants of the two perovskite single crystals are matched,another crystal can be grown on the surface of one crystal by epitaxial growth.The whole epitaxy growth process does not require high heating temperature and long heating time.X-ray diffraction method is used to prove the lattice plane of the substrate and the epitaxial grown layer.A scanning electron microscope is used to measure the thickness of the epitaxial layer.Compared with perovskite-based photodetectors without epitaxial growth layer,perovskite-based photodetectors with epitaxial growth layer have lower dark current density and higher optical responsibility.     

就单摆问题引入大学物理教学新模式

单摆教学的过程中引入MATLAB数值计算的教学新模式,可以有效地改善大学物理教学的枯燥方式,有助于提高学生对大学物理课中抽象的、复杂的物理现象和规律的理解,也有助于促进对所学数学知识的实际应用.这种新教学模式是深化高等工程教育改革、加快新工科建设、促进创新型工科人才培养的有效手段.     

超空泡射弹水下侵彻靶板三相耦合数值模拟

超空泡射弹侵彻问题的实质是特殊水下结构受到高速冲击载荷作用下的动态响应。对12.7 mm口径超空泡射弹侵彻典型水下目标壳体的毁伤效果开展研究,基于LS-DYNA有限元分析软件建立水环境中超空泡射弹垂直侵彻曲面靶板的等效模型,探讨射弹侵彻过程中动能侵彻和气泡溃灭对靶板联合毁伤效果,获得了靶板在各阶段的应力变化和结构变形规律。结果表明:侵彻靶板前,射弹着靶速度为200 m/s时的头部表面水介质压力峰值达768 N,靶板表面有明显下凹变形;侵彻靶板时,伴随着射弹动能侵彻和气泡溃灭冲击,水介质造成的影响不足动能侵彻的2%;侵彻靶板后,在靶板正面形成峰值速度为42 m/s的水射流进一步作用于破口;靶板整体弯曲变形,在200~300 m/s范围内,随着射弹着靶速度的增加,靶板弯曲形变量减小;靶板局部发生延性穿孔,射弹在水环境中具有更好的破口效果,射弹速度变化对破口尺寸影响不大。     

白色荧光粉CaF2∶Yb3+/Eu3+/La3+的制备及其上转换发光特性

采用改进的两步高温固相熔融法制备了Yb^3+、Eu^3+、La^3+共掺杂CaF 2的上转换荧光粉。基于荧光猝灭原理,通过改变La^3+掺杂浓度来调节CaF 2∶Yb^3+/Eu^3+材料的发光性能,并在980 nm近红外光激发下,获得了该材料的白色上转换发光(UCL)。在该发光体系中,Yb^3+不仅起到了敏化Eu^3+的作用,同时,Yb^3+二聚体(Yb^3+-dimer)自身合作发出波长范围480~540 nm的绿色荧光。而白光三基色中的绿光正是来自Yb^3+二聚体的合作发光。Eu^3+则作为激活剂,同时发出红色和蓝色荧光。荧光寿命测试结果表明Yb^3+-dimer与Eu^3+之间存在有效的能量传递。值得注意的是,在980 nm激光激发下,1%La^3+掺杂的样品表现出最佳的红、绿、蓝三基色光比列,实现了材料的上转换白光发射,其色度坐标为(0.311,0.340)。